LK166
Home >> Download >> MITSUBISHI >> Manual Download >> MITSUBISHI A1SY28A User's Manual PDF

MITSUBISHI A1SY28A User's Manual PDF

Brand: MITSUBISHI
Product model: A1SY28A
Name: I/O Module
Sort: User's Manual
File language: English
File size: 5.14MB
Fast connector type.
Current input.
Number of channels: 8 channels.
Occupied the number of stations: Ver.1 mode occupied 3 stations, Ver.2 mode occupied 1 stations A1SY28A PDF.
Station type: remote equipment station.
MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction.
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram A1SY28A
Electrical interconnection diagram of each part of the design system.
According to the construction drawings of the site wiring, and carry out a detailed inspection A1SY28A PDF.
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced.
MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust A1SY28A PDF.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actuual load and so on and so on step by step A1SY28A Manual.
If you do not meet the requirements, the hardware and procedures for adjustment MITSUBISHI User's Manual.
Usually only need to modify the part of the program can be. Output points: 4 points.
Output voltage and current: DC24V/AC240V, 2A/1 point, 8A/1 common end.
Output response time: 12ms.
4 point /1 a public side.
Output form: relay output MITSUBISHI User's Manual.
16 point terminal station.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered.
It can avoid the control logic confusion caused by illegal operations.
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system MITSUBISHI User's Manual.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc..
MITSUBISHI PLC prograam simulation debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of thee program A1SY28A Manual A1SY28A User's Manual.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation.
Related products
MITSUBISHI
Network module
A1SJ71LR21
MITSUBISHI Network module A1SJ71LR21
3C-2V/5C-2V coaxial cale etween doule loop
MITSUBISHI
Analog input module
A1S68AD
MITSUBISHI Analog input module A1S68AD
8 channel analog input module. This is a high
MITSUBISHI
Melsecnet interface module
A1SJ71AP21GE
MITSUBISHI Melsecnet interface module A1SJ71AP21GE
PLC station distance: 2Km. Cale type: GI-62.
MITSUBISHI
output module
A1SY81
MITSUBISHI output module A1SY81
Output type: transistor source. Output points