MITSUBISHI FX3G-40MT/ES-A USER'S MANUAL (MODBUS Serial Communication Edition) PDF

Function: bus convert FX5 to FX3.
Input and output points: 8 points.
Conversion module connecting FX3 series expansion module.
FX3 series expansion module, only the right side of the bus conversion module can be connected FX3G-40MT/ES-A PDF. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 18.5kw.
SLD converter rated current: 93A.
Structure and function: Standard model FX3G-40MT/ES-A
Type: CA.
Substrate coating: have.
PID target value can be set directly from the operator panel. Flexible change settings.
In the 1 inverter, through the PID control of parallel connection pump (up to 4 units) can adjust the amount of water and so on FX3G-40MT/ES-A PDF.
1 pumps driven by parallel connection of the pump machine, in addition to the pump for power frequency drive.
The numberr of power frequency driven pump, according to the automatic adjustment of water FX3G-40MT/ES-A Manual.
The liquid crystal panel options (FR-LU08) can be converted to a more intuitive display unit% units FX3G-40MT/ES-A PDF.
Through the use of wind, temperature and other familiar units can be simple to maintain and adjust the display. Number of input channels: 4 channels.
Voltage input: DC-10~10V.
Current input: DC4~20mA, DC-20~20mA.
Programmable logic controller: FX2NC, FX3UC MITSUBISHI USER'S MANUAL.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc.).
Indispensable analog control in FA control,
It is easy to implement on a programmable logic controller. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 5 MITSUBISHI USER'S MANUAL. 5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station MITSUBISHI USER'S MANUAL FX3G-40MT/ES-A USER'S MANUAL.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX3G-40MT/ES-A Manual.
No external PID controller is used to control the external machine, so the system cost can be reduced.