MITSUBISHI Q13UDHCPU User's Manual (Application) PDF

GI-62.5/125 optical cable.
Double ring.
Remote I/O net (remote I/O station).Input / output points: 256 points.
Program capacity: 8 K step.
Processing speed: 0 Q13UDHCPU PDF. 2 s.
Built in communication port: RS232*1.
Continue to go beyond, to climb the peak of Q series.
Strengthen security function.
Can be set up to 32 characters of the file password.
In addition to the English letters, numbers, but also the use of special characters,
To further enhance the security of the password Q13UDHCPU
In addition, only pre registered devices are allowed to access CPU,
To intercept unauthorized access to unauthorized users.
Therefore, it is important to prevent the outflow of important program assets and protect intellectual property rights Q13UDHCPU PDF.
CPU module expansion standard RAM (max 8MB).
Can be used with the SD memory card at the same time.
Continuous access file register."Maximum control axis: 4 axis.
Connection mode with servo amplifier: SSCNET III /H connection type Q13UDHCPU PDF Q13UDHCPU Manual.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible MITSUBISHI User's Manual.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc MITSUBISHI User's Manual. .
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported MITSUBISHI User's Manual.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thhus greatly reducing wiring Q13UDHCPU User's Manual.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q13UDHCPU Manual. "