MITSUBISHI QJ71FL71-T-F01 User's Manual PDF

Control axis: up to 16 axes.
Interpolation function: linear interpolation (maximum 4 axis), arc interpolation (2 axis), spiral interpolation (3 axis).
PLC capacity: 30K step QJ71FL71-T-F01 PDF.
Small scale systems with high performance to price ratio.
Power supply, programmable sensor, motion controller trinity.
Maximum control axis: 16 axis.
Support visual system.8 channel.
Input: DC4~20mA.
Output (resolution): 0~6400; 0~3200 QJ71FL71-T-F01
Conversion speed: 10ms/ channel.
18 point terminal station.
Isolation between channels.
Power supply to a two wire transmitter.
The possibility of expanding control with intelligent function QJ71FL71-T-F01 PDF.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark.
Provide support for process control using a general purpose programmable controller.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output QJ71FL71-T-F01 PDF.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc..
Standard analog input module MITSUBISHI User's Manual.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module.Cable length 0.45 meters.
Extended substrate for connection.8 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module MITSUBISHI User's Manual.
Base plate of AnS series PLC.
QA1S series PLC 8 slot main substrate.
AnS series of modules can be innstalled QJ71FL71-T-F01 Manual. "Maximum control axis: 2 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m MITSUBISHI User's Manual.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 2 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus grreatly reducing wiring QJ71FL71-T-F01 User's Manual.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) QJ71FL71-T-F01 Manual. "