MITSUBISHI QJ71LP21G User's Manual (Hardware) PDF

Program capacity: 252 K step.
Input / output points: 4096 points.
Number of input and output elements: 8192.
Processing speed: 0.034 s.
Program memory capacity: 1008 KB QJ71LP21G PDF.
Support USB and RS232.
Durable redundant CPU.
The position signal of the first axis servo amplifier, which is used on the motion CPU, is used as a trigger,
Starting from the programmable controller CPU to the second axis servo amplifier,
Time to output speed command of servo amplifier QJ71LP21G
This time is the index of data transmission speed between CPU.Q6TA32 special tool.Master station.
Province distribution network module in cabinet and device QJ71LP21G PDF.
Link to connect the 64 stations when the fastest scanning time for 1.2ms (rate 2.5Mbps).
According to the transmission distance, the transmission rate is selected from 2.5Mbps, 625kbps and 156kbps.
CC-Link/LT from the station does not need any parametter settings QJ71LP21G Manual.
Only need to set up the transmission speed in the master module, you can use the remote I/O QJ71LP21G PDF.
QJ61CL12 can be used as the main station of CC-Link/LT.Three-phase 3 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc MITSUBISHI User's Manual. .
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information MITSUBISHI User's Manual.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment MITSUBISHI User's Manual.
3 phase 3 wire products can be used too measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products QJ71LP21G User's Manual.
For example, a module ccan be used to measure other loads from the control panel trunk QJ71LP21G Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.