For 5.7 inch models, for fixing the hooks of the three EX modules.5.7 inches, for the protection of the man-machine interface from oil and chemical pollution (5 / set) CA5-USBEXT-01 PDF. Expansion module for the GP3000 access to the CANopen network and communication with the CANopen master stationCOM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connector12
CA5-USBEXT-011 inches, replaced by a host of backlight (1).COM2 terminal adapter for communication through the RS-422/485 connectionMounting screws (4 sets) to be fitted to the hard panel at the interface of the machine CA5-USBBEXT-01 PDF CA5-USBEXT-01 Manual. Adapter for EX module (5 / set)10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.10.4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set) CA5-USBEXT-01 PDF. 10.4 inches (TFT), the GP will be installed to the hard panel to provide dust and moisture proof function.For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set).256MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface User's Manual. USB cable clamp for preventing disconnection of connection (5 / set)The main controller is connected to the man-machine interface for MPI communicationUSB cable to prevent disconnection of the fastening clip (5 / set)5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) Proface User's Manual. COM1 pin adapter, whicch is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface CA5-USBEXT-01 User's Manual. Expansion module for the GP3000 access to the CC-Link network and communication with the CC-Link master staation (support for intelligent devices)COM1 interface with the cable (RS-232C), used to connect directly to the SYSMAC connection module (or other host)