MITSUBISHI FR-A740-11K-C9 INSTRUCTION MANUAL (BASIC) PDF

MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 30kw.
SLD converter rated current: 154A.
Structure and function: Standard model FR-A740-11K-C9 PDF.
Type: CA.
Substrate coating: have.
PID target value can be set directly from the operator panel. Flexible change settings.
In the 1 inverter, through the PID control of parallel connection pump (up to 4 units) can adjust the amount of water and so on FR-A740-11K-C9
1 pumps driven by parallel connection of the pump machine, in addition to the pump for power frequency drive.
The number of power frequency driven pump, according to the automatic adjustment of water FR-A740-11K-C9 PDF.
The liquid crystal panel options (FR-LU08) can be converted to a more intuitive display unit% units.
Through thee use of wind, temperature and other familiar units can be simple to maintain and adjust the display FR-A740-11K-C9 Manual. Power: 160kw.
Voltage: 400V.
The power factor of the input power factor is up to 0 FR-A740-11K-C9 PDF. 99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Convert connector to screw relay terminal.
The action of the signal of the conversion module is shown in the light of the lamp.
Positive common end display MITSUBISHI INSTRUCTION MANUAL. Use: can choose any 3 signal relay output from the converter standard output signal.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. Function: bus convert FX5 to FX3.
Input and output points: 8 points.
Conversion module connecting FX3 series expansion module MITSUBISHI INSTRUCTION MANUAL.
FX3 series expansion module, only the right side of the bus conversion module can be connected. Power: 75kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.

Equipped with standard power retrogradation function MITSUBISHI INSTRUCTION MANUAL FR-A740-11K-C9 INSTRUCTION MANUAL. Memory format: EEPROM.
Number of steps: up to 2000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device iss installed on the PLC, and is written and deleted by the peripheral device FR-A740-11K-C9 Manual.
Note: the built-in program transfer function (FX1S and FX1N host generic).