MITSUBISHI FR-A740-18.5K-CHT INSTRUCTION MANUAL (BASIC) PDF

Input and output points: 40 points.
Power supply: DC24V.
Input points: 24 points.
Output points: 16 points.
Output form: transistor output (drain).
Power consumption: 25W FR-A740-18.5K-CHT PDF.
Weight: 0.7KG.
Outline dimension: 130x90x86mm.
FX3GE on the performance of the FX3GA increased analog input / output and Ethernet communication and other built-in features.
Applicable to a wide variety of applications FR-A740-18.5K-CHT
Basic unit: 24/40 point.
Third generation standard model.
High flexibility.
Suitable for small scale control of high cost PLC.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points FR-A740-18.5K-CHT PDF.
A versatile PLC.
Built in CPU, power supply, input and output, analog input and output, Ethernet port, can be used immediately after the purchase.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps FR-A740-18.5K-CHT PDF.
EEPROM memory cartridge with program transfer function. Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. Positive common end use. MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V MITSUBISHI INSTRUCTION MANUAL.
Frequency converter capacity: 1.5KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible MITSUBISHI INSTRUCTION MANUAL.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used FR-A740-18.5K-CHT Manual. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI INSTRUCTION MANUAL.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Input and output points: 30 points.
Power supply: DC24V.
Input points: 16 points.
Output points: 14 points.
Output form: transistor output (source).
Power consumption: 8.5W.
Weight: 0.35KG.
Outline dimension: 100x90x49mm.
Built in CPU, power supply, input and output.
Keep FX1S compact body, while adding more features.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction
Application instruction: 0.5 s/ instruction
Large capacity memory.
Built in program memory 4000 steps.
No battery.
Auxiliary relay: 1536 points.
Timer: 138 points.
Counter: 67.
Data register: 3000.
A new application model.
FX3SA is a basic moodel on the basis of the basic performance of the FX1S increased the expansion of the new models FR-A740-18.5K-CHT INSTRUCTION MANUAL.
FX3SA is suitable for all kinds of fields, such as analog quantity, Ethernet, MODBUS function, small scale equipment and so onn FR-A740-18.5K-CHT Manual.
Basic models suitable for small scale control.
Compact but powerful,
At the same time, the analog quantity and the communication function and so on.