MITSUBISHI FR-A840-01800-2-60 Instruction manual (DETAILED) PDF

MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 11kw.
SLD converter rated current: 63A.
Structure and function: Standard model FR-A840-01800-2-60 PDF.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FR-A840-01800-2-60
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine FR-A840-01800-2-60 PDF.
No external PID controller is used to control the external machine, so the system cost can be reduced. MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 315kw.
SLD converter rated current: 770A.
Structure and function: the rectification part is off type FR-A840-01800-2-60 PDF.
Type: CA.
Substrate coating: have.
To maximize the performance of the motor.
Advanced auto tuning function.
The newly developed PM motor auto tuning featurre can be used to operate other manufacturers of PM motors (Yong Ci synchronous motors) in the sensorless state MITSUBISHI Instruction manual FR-A840-01800-2-60 Manual .
Not only can drive MITSUBISHI induction motor and PM motor, but also can drive other manufacturers of induction motor and PM motor.
This means that you can reduce the cost of inventory and supplies.
If the PM motor is produced by a IPM motor or other company using MM-CF, the starting torque is limited to 50%,
Even after tuning is not simple to use and positioning control of zero speed torque) induction motor and permanent magnet motor can be combined freely MITSUBISHI Instruction manual. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 18.5kw.
SLD converter rated current: 38 MITSUBISHI Instruction manual. 0A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Giive full play to the performance of the motor FR-A840-01800-2-60 Instruction manual.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FR-A840-01800-2-60 Manual .