MITSUBISHI FR-A840-12120-2-60 Programming Manual (PLC FUNCTION) PDF

Input / output mode: transistor output (drain).
Output points: 8 points.
DC5V internal consumption current: 75mA.
DC24V internal consumption current: 75mA FR-A840-12120-2-60 PDF.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-A840-12120-2-60 Input / output type: transistor output (source).
Output points: 16 points.
Input and output points: 16 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure FR-A840-12120-2-60 PDF.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed couunter automatically adjusted to the minimum value FR-A840-12120-2-60 PDF FR-A840-12120-2-60 Manual .
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module MITSUBISHI Programming Manual.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V MITSUBISHI Programming Manual.
The number of connection points depends on the basic unit and the expansion unit. "Power: 15kw.
Voltage: 400V.
Brake resistor, a kind of ripple resistance, is mainly used in the mechanical system of the inverter to control the speed of the motor,
Help the motor to be converted into heat energy due to the regenerative power of the motor MITSUBISHI Programming Manual.
Brraking unit principle: the brake unit is composed of a high power transistor GTR and its driving circuit FR-A840-12120-2-60 Programming Manual.
Its function is to link the discharge current braking resistor capacitor voltage or not in the range of the time connsumed and the DC part "overpressure",
Need to add external braking components, in order to speed up the speed of the consumption of renewable energy FR-A840-12120-2-60 Manual . "