MITSUBISHI FR-F740P-11K-CHT Instruction manual (BASIC) PDF

MITSUBISHI inverter FR-D720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 1.5KW.
Vector control variable frequency speed control is the practice of the asynchronous motor in the three-phase coordinate system of the stator current Ia, Ib, Ic, through the three-phase to two-phase transformation,
The alternating current of Ia1Ib1 is equivalent to a two phase stationary coordinate system, and then is rotated by the rotor field oriented,
Equivalent to the DC current Im1, It1 (Im1 equivalent to DC motor excitation current in synchronous rotating coordinate system;
It1 equal to the armature current proportional to the torque, and then imitate the DC motor control method, to obtain the DC motor control,
The control of asynchronous motor is realized through the corresponding inverse coordinatte transformation FR-F740P-11K-CHT PDF FR-F740P-11K-CHT PDF FR-F740P-11K-CHT Manual FR-F740P-11K-CHT MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V FR-F740P-11K-CHT PDF.
Frequency converter capacity: 3.7KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible MITSUBISHI Instruction manual.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI Instruction manual.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Input / output form: relay output.
Output points: 8 points.
DC5V internal consumption current: 75mA MITSUBISHI Instruction manual FR-F740P-11K-CHT Instruction manual.
DC24V internal consumption current: 75mA.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion modulee: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-F740P-11K-CHT Manual .