MITSUBISHI FR-F740P-280K-CHT Instruction manual (BASIC) PDF

Length: 1.5m.
Specifications: FX circular connectors, FX-232AWC-H between. MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 3 FR-F740P-280K-CHT PDF. 7KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FR-F740P-280K-CHT
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FR-F740P-280K-CHT PDF.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft FR-F740P-280K-CHT PDF. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 11kw.
SLD converter rated current: 63A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation MITSUBISHI Instruction manual.
(rectifier separation type will vary)
Also, but also through the use oof options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FR-F740P-280K-CHT Manual .
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine MITSUBISHI Instruction manual.
No external PID controller is used to control the external machine, so the system cost can be reduced. Total input and output points: 48 points.
Input points: 24 points.
Output points: 24 points MITSUBISHI Instruction manual.
Output type: transistor output.
Power supply voltage: DC24V.
Input signal voltage: DC24V.
FX2N series expansion unit
Expansion unit is an input and output expansion device with a built-in power supply.
As with the basic unit, the extension unit can be connected to a variety of input and output and special extension equipment.
Can connect to FX3GA/FX3G, FX3GE and FX3U.
AC power model, the built-in maximum DC24V 250mA/460mA supply power.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One partt as digital filter,
Sensitivity adjustment unit can reach 1ms FR-F740P-280K-CHT Instruction manual.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis FR-F740P-280K-CHT Manual .
Extended function expansion board and special adapter,
Data links and communication with external serial devices.