MITSUBISHI FX3G-60MR/DS HARDWARE MANUAL PDF

Can be used as a screw relay terminal.MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 0.75KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FX3G-60MR/DS PDF FX3G-60MR/DS
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FX3G-60MR/DS PDF.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Input and output points: 20 points FX3G-60MR/DS PDF.
Power supply: AC100-240V.
Input points: 12 points.
Output points: 8 points.
Output form: relay output.
Power consumpption: 20W FX3G-60MR/DS Manual.
Weight: 0.4KG.
Outline dimension: 75x90x75mm.
A new application model.
FX3SA is a basic model on the basis of the basic performance of FX1S above the expansion of the expansion of the new model MITSUBISHI HARDWARE MANUAL.
FX3SA is applicable to all kinds of fields of small scale equipment which need to simulate the quantity and function of MODBUS and Ethernet.
Basic models suitable for small scale control.
Compact but powerful,
At the same time, the analog quantity and communication function, etc MITSUBISHI HARDWARE MANUAL. . Input output cable for A6TBXY36 type connector / terminal row conversion module.
Length 5M. MITSUBISHI inverter FR-D720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 0.2KW.
Vector control variable frequency speed control is the practice of the asynchronous motor in the three-phase coordinate system of the stator current Ia, Ib, Ic, through the three-phase to two-phase transformation,
The alternating current of Ia1Ib1 is equivalent to a two phase stationary coordinate system, and then is rotated by the rotor field oriented,
Equivalent to the DC currrent Im1, It1 (Im1 equivalent to DC motor excitation current in synchronous rotating coordinate system;
It1 equal to the armature current proportional to the torque, and then imitate the DC motor control method, to obtain the DCC motor control,
The control of asynchronous motor is realized through the corresponding inverse coordinate transformation MITSUBISHI HARDWARE MANUAL FX3G-60MR/DS Manual FX3G-60MR/DS HARDWARE MANUAL.