MITSUBISHI GT2710-STBA Connection Manual (Mitsubishi Products) PDF

Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Bus connection (2 channel) unit standard model for QnA/ACPU/ transport controller CPU (A series) GT2710-STBA PDF.
Applicable models: GT15, GT16. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color GT2710-STBA
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422 GT2710-STBA PDF.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system GT2710-STBA PDF MITSUBISHI Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI Connection Manual. Cable length: 3m.
The connection between Q/LCPU and GOT/ personal computer /GTSoftGOT1000 (D-SUB9).
Applicable models: GT16, GT15, GT11, GT10, GT27, GT25, GT23, GT21. Cable length: 0.6m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between A7GT-CNB MITSUBISHI Connection Manual.
Applicable models: GT16, GT15, GT11. RS-232 serial communication unit (D-sub9 pin (header).
Applicable models: GT15, GT16, GT27, GT25. Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embeddedd communications capabilities) GT2710-STBA Manual .
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or usee dry cloth touch screen on the surface of the water GT2710-STBA Connection Manual.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it GT2710-STBA Manual .