MITSUBISHI L26CPU-PBT PROGRAMMING Guide Book (Structured Text(ST)) PDF

Input and output (DC/ differential).
Input points: 12 points (DC5V/DC24V/ differential universal).
Pulse input speed: the highest pulse/s 8M (2MHz).
Output points: 8 points (DC5V ~ DC24V) 6 points (differential) L26CPU-PBT PDF.
Pulse output speed: the highest pulse/s 8M (2MHz).
High speed and stable input / output response
The high speed response can be achieved without the CPU module''s operation and bus performance,
Stable input and output response through hardware processing L26CPU-PBT
LD40PD01 is equipped with an external input and output interface and FPGA,
Therefore, high speed control can be realized without the influence of the scanning time of the CPU module and the bus performance (the input and output response time of the s instruction is realized) L26CPU-PBT PDF.
Can achieve stable input and output response (processing time of the deviation of the ns level).
Through the intuitive tools for FPGA settings.
In the FPGA design process can be omitted in the past must be designed to deal with (HDL description, logic synthesis and time verification),
Reduce working hours L26CPU-PBT PDF. Aftter receiving the product can be used immediately to verify the use of special tools, can significantly shorten the design time L26CPU-PBT Manual . AnyWireASLINK master station MITSUBISHI PROGRAMMING Guide Book.
Transmission distance: the longest 200m.
Data input and output: up to 512 points.
Connect up to 128 units.
Enter 256 points, 256 points out of the output.
Connecting the input and output of the sensor to the programmable controller.
Ultra small sensor can be freely configured to control the input and output of 512 points MITSUBISHI PROGRAMMING Guide Book.
In addition, the sensor can be supplied with a AnyWireASLINK transmission line (2 lines) by means of communication,
So as to facilitate additional sensor.
And can also be through the engineering software Works2 GX batch management sensor disconnection detection and from the station module settings, etc MITSUBISHI PROGRAMMING Guide Book. ,
Can significantly reduce the engineering hours.
Basic composition.
AnyWireASLINKAnyWireASLINK can be selected according to the load current of 2 wire or 4 wire from the station module.
In addition to the 2 wire type, the local ppower supply can be connected with the 4 wire type mixed use L26CPU-PBT PROGRAMMING Guide Book.
2 wire type.
The load current is less than that of the hour, by using the non isolated 2 wire type from the station module,
Easy connection without using local power suupply L26CPU-PBT Manual .
4 wire type
By using isolated 4 wire type from the station module, the local power supply can be used,
Can support the use of more current load.