MITSUBISHI MR-J2-100A Specifications and Installation Guide PDF

"MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 3.5kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V MR-J2-100A PDF.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance MR-J2-100A
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system MR-J2-100A PDF.
This simple connection method reduces the routing time and helps to prevent noise.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system MR-J2-100A PDF.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. "TType: MR-J series MR-J2-100A Manual.
Rated output: 2.0KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor MITSUBISHI Specifications and Installation Guide.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MITSUBISHI Specifications and Installation Guide.
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MITSUBISHI Specifications and Installation Guide.
Encoder serial communication system, the communication frequency can only be limited to 10M. MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.2kw.
AC serrvo control system includes AC servo system based on asynchronous motor and AC servo system based on synchronous motor MR-J2-100A Specifications and Installation Guide.
Besides the advantages of good stability, good rapidity and high accuracy, the advantages of.
Its performance iindicators can be measured from the speed range, positioning accuracy, the accuracy of stability, dynamic response and operational stability and so on MR-J2-100A Manual.