MITSUBISHI MR-J3-10T INSTRUCTION MANUAL (General-Purpose Interface) PDF

1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 3.5kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V MR-J3-10T PDF.
Special specification: full closed loop control 4 wire / device end encoder ABZ phase input corresponding support function security unit, support positioning mode.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication MR-J3-10T
Can be combined with the servo system controller to maximize the performance of the servo system.
Improve mechanical properties by high performance motor MR-J3-10T PDF.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rotation.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment MR-J3-10T PDF.
Easily start advanced seismic function, it can maximize the mechanical properties.
It can automatically adjust the required response settings automatically. Type: MR-C type.
Symbbol 10A for motor models: HC-PQ43 MR-J3-10T Manual.
Power supply voltage: single phase AC220V.
Drive: servo drive in the development of the premise of the frequency conversion technology,
Current loop in the drive,
Speed loop and position loop (frequency converter without the ring) have carried out a more precise control than the general frequency control technology and algorithm,
In function is also a lot stronger than the traditional servo,
The main point can be precise position control MITSUBISHI INSTRUCTION MANUAL MITSUBISHI INSTRUCTION MANUAL.
The control speed and position are controlled by the pulse sequence transmitted by the upper controller,
The internal algorithm of the driver and the faster and more accurate calculation and better performance of electronic devices to make it more superior to the inverter MITSUBISHI INSTRUCTION MANUAL. "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 3.5kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CCC-Link
Simply setting the point table MR-J3-10T INSTRUCTION MANUAL.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and dissplay can also be transmitted through the CC-Link MR-J3-10T Manual.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "