MITSUBISHI MR-J3-60T4 INSTRUCTION MANUAL (General-Purpose Interface) PDF

MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.1kw.
Interface type: SSCNET type III fiber communication.
Power specification: single phase AC200V MR-J3-60T4 PDF.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed.
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring MR-J3-60T4
Due to the adoption of the optical fiber communication, the anti noise ability can be greatly improved andd the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized MR-J3-60T4 PDF MR-J3-60T4 Manual.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable for mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties MR-J3-60T4 PDF. Drive: MR-H_ACN series CC-LINK features.
Rated output: 0.6KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MITSUBISHI INSTRUCTION MANUAL.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MITSUBISHI INSTRUCTION MANUAL. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MITSUBISHI INSTRUCTION MANUAL MR-J3-60T4 INSTRUCTION MANUAL.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-J3-60T4 Manual.