MITSUBISHI MR-J3-60T4 INSTRUCTION MANUAL (CC-Link) PDF

Cable length: 10m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MR-J3-60T4 PDF.
Rated output: 1.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for linear servo motor.
Power specification: three phase AC200V.
More advanced real-time automatic tuning by setting response values,
Including the position gain and the gain of speed, all the gain can be adjusted automatically MR-J3-60T4
32 segment response level can be set.
Advanced vibration suppression control MR-J3-60T4 PDF.
An optimal vibration control filter value is automatically set by the automatic tuning function to effectively suppress the vibration of the 100Hz frequency that occurs when the driving part stops.
The automatic tuning function can effectively restrain the vibration of the end of the mechanical arm and reduce the residual vibration in the machinne MR-J3-60T4 PDF MR-J3-60T4 Manual. The length of the line: 2M.
IP level: IP65.
Relay type.
Bending life: standard.
The cable is not shielded.
Electric motor power supply cable (motor side), for HF-KP/HF-MP series (motor shaft with side extraction). The cable is required to diagnose the function using the MRConfigurator (servo setup software) amplifier MITSUBISHI INSTRUCTION MANUAL. Drive: MR-H_ACN series built-in positioning function.
Rated output: 2.0KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop MITSUBISHI INSTRUCTION MANUAL.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimum detectablle speed MITSUBISHI INSTRUCTION MANUAL MR-J3-60T4 INSTRUCTION MANUAL.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MR-J3-60T4 Manual.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.