MITSUBISHI Q06HCPU Programming Guide Book (Structured Text(ST)) PDF

8 axes.
Connect SSCNET III.
Control unit: pulse.
Location data: 32 data / axis.
Ideal solution for simple multi axis positioning.
A variety of functions, such as positioning control, constant velocity control, and other positioning control systems Q06HCPU PDF.
The multi axis system is most suitable for simple positioning control.
Ideal selection for high speed linear positioning control in multi axis system Q06HCPU
Linear interpolation operation with up to 4 axes can be carried out.
With the electronic gear, gap compensation, absolute position system, such as basic positioning function. Control axis: maximum 8 axes Q06HCPU PDF.
Greater flexibility.
PLC control and motion control using independent CPU, optimize the system configuration.
More than 4 CPU modules can be freely selected in multi CPU system.
MITSUBISHI SSCNET control function.
By using the high speed serial communication mode, we can easily construct the synchronization system of the servo motor Q06HCPU PDF.
The motion controller and the servo amplifier can be quickly connected by a connector, and the connection is simplified.
Each 1 CPU can control up to 32 axes at the same time.
Can control the small capacity from 10W to 55KW large capacity servo motor.
Through the use of digital oscilloscope function, can be uused to control the power distance, speed, position and other motor information monitoring MITSUBISHI Programming Guide Book Q06HCPU Manual. SRAM memory card.
RAM capacity: 256KB. Master station.
Province distribution network module in cabinet and device.
Link to connect the 64 stations when the fastest scanning time for 1 MITSUBISHI Programming Guide Book. 2ms (rate 2.5Mbps).
According to the transmission distance, the transmission rate is selected from 2.5Mbps, 625kbps and 156kbps.
CC-Link/LT from the station does not need any parameter settings.
Only need to set up the transmission speed in the master module, you can use the remote I/O MITSUBISHI Programming Guide Book.
QJ61CL12 can be used as the main station of CC-Link/LT.Meet safety standards: EN954-1 class 4, 13849-1 PL e ISO.
Safe input points: 1 points (2 input).
Start input points: 1.
Input type: N type (positive public end / negative public end input)
Safe output points: 1 points (3 output).
Spring clip terminal.
Additional security system.
Simply connect to the existing CC-LINK, you can add an independent security features.
Saving wiring by CC-link connnection Q06HCPU Programming Guide Book.
The wiring is not needed in particular to the condition monitoring of the safety relay module, and realizes the wiring of the cabinet and the other provinces.
Visualization of installation status.
Can monitor the safe output,, as well as the safety input and the internal state of the relay, in the safety circuit to facilitate the identification of the reasons for the start Q06HCPU Manual.