MITSUBISHI Q100UDEHCPU Programming Guide (Structured Text) PDF

Input / output points: 256 points.
Program capacity: 8 K step.
Processing speed: 0.2 s.
Built in communication port: RS232*1.
Continue to go beyond, to climb the peak of Q series Q100UDEHCPU PDF.
Strengthen security function.
Can be set up to 32 characters of the file password.
In addition to the English letters, numbers, but also the use of special characters,
To further enhance the security of the password Q100UDEHCPU
In addition, only pre registered devices are allowed to access CPU,
To intercept unauthorized access to unauthorized users.
Therefore, it is important to prevent the outflow of important program assets and protect intellectual property rights Q100UDEHCPU PDF.
CPU module expansion standard RAM (max 8MB).
Can be used with the SD memory card at the same time.
Continuous access file register.2 axes, open collector output type.
2 axis linear interpolation.
2 axis interpolation.
Control unit: mm, inch, degree, pulse Q100UDEHCPU PDF.
Location data: 600 data / axis.
Maximum pulse output: 2000Kpps Q100UDEHCPU Manual .
40 pin connector.
Positioning module.
Open collector output.
Differential driver output.
Based on the use of open collector outputs and differential drive output type 2 types.
Differential driver output type positioning module can transmit high speed instruction pulse (up to 4Mpps) to the servo amplifier reliably,
Transmission distance of up to 10 meters, to achieve high speed and high precision control MITSUBISHI Programming Guide.
(the command pulse of the open collector positioning module is highest 200kpps.) "1 axes, SSCNET III type.
Control unit: mm, inch, degree, pulse MITSUBISHI Programming Guide.
Location data: 600 data / axis.
40 pin connector.
Through the SSCNET III cable connection to save wiring, the distance between the station up to 50m.
Absolute position system for determining the origin position is supported by the return data set operation.
In addition, the limit switch of the upper limit, the lower limit switch and the near point block signal input can be directly connected to the servo amplifier,
Thus greatly reducing the wiring requirements MITSUBISHI Programming Guide.
Easy tto achieve high speed, high precision positioning control Q100UDEHCPU Programming Guide.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, ppath switching control, constant speed control etc Q100UDEHCPU Manual . .
In addition, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug. "