MITSUBISHI Q173DCPU-S1 Programming Manual (Special Instructions) PDF

Positioning: 3 axis, built-in counter function, open collector output type.
Control unit: pulse.
Number of location data: 1/ axis.
Maximum output pulse: 100Kpps Q173DCPU-S1 PDF.
Counter: 3 channels.
100Kpps.
Counter input signal: DV5~24V.
40 pin connector.
Positioning control using encoder feedback, especially suitable for conveying system and processing machinery, etc..
In the 1 single module, the 3 axis positioning function and the 3 channel counter function are integrated Q173DCPU-S1
Positioning module, high-speed counter module combined as a whole,
Can effectively use the board slot and save space. SRAM memory card, capacity: 2M bytes Q173DCPU-S1 PDF.
Size: 45*42.8*3.3mm
Weight: 15g.
Support SD memory card.
High speed universal QCPU support SD memory card,
In order to be able to have a memory card port between SD and PC to easily realize data exchange.
In addition, the SD memory card and the extended SRAM card can be used simultaneously Q173DCPU-S1 PDF.
Therefore, the extension of the file register using the extended SRAM card,
SD memory card can be used at the same time to carry out the data ffile record, a large number of annotation data storage, through the memory card to guide operation Q173DCPU-S1 Manual .
Better user experience data recording function MITSUBISHI Programming Manual.
Easy to record, no need to program.
Simply through the special configuration tool wizard to easily complete the settings,
The collected data can be saved in CSV format to SD storage card.
Can be effectively used to save the CSV file to facilitate the creation of a variety of reference materials,
Including daily reports, generate reports and general reports MITSUBISHI Programming Manual.
These data can be applied to the data analysis, tracing, etc..
To record the change of control data without missing.
Data can be collected in a time interval or in a millisecond time interval,
To record the change of the specified control data without any omission MITSUBISHI Programming Manual.
Therefore, in the event of failure, can quickly determine the cause, the precise action analysis.Control axis: maximum 32 axes.
Manual pulse generator operation function: can use 3 sets of manual pulse generator.
Synchronous encoder operation function: cann use 12 synchronous encoder Q173DCPU-S1 Programming Manual.
Peripheral I/F: by CPU PLC.
High speed motion control system based on multi CPU architecture.
Multi CPU system based on Q series PLC.
Flexible selection of CPU PLC and motion CPU according to differeent applications Q173DCPU-S1 Manual .
In the construction of multi CPU system, can have up to 4 sets of CPU.
When 3 Q173DCPU is used, the maximum 96 axes can be controlled.