MITSUBISHI Q25PRHCPU Strctured Programming Manual (Special Instructions) PDF

"Maximum control axis: 2 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m Q25PRHCPU PDF.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 2 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network Q25PRHCPU
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control Q25PRHCPU PDF.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayeed synchronously with the motion controller Q25PRHCPU Manual.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported Q25PRHCPU PDF.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc MITSUBISHI Strctured Programming Manual. .
Positioning module (QD75MH) of the project and the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS). "1 slots; no power supply; used to install large PLC series AnS module MITSUBISHI Strctured Programming Manual.
Base plate of AnS series PLC.
QA1S series PLC 1 slot main substrate.
AnS series of modules can be installed. Master station.
Province distribution network module in cabinet and device.
Link to connect the 64 stations when the fastest scanning time for 1.2mms (rate 2 Q25PRHCPU Strctured Programming Manual. 5Mbps) MITSUBISHI Strctured Programming Manual.
According to the transmission distance, the transmission rate is selected from 2.5Mbps, 625kbps and 156kbps.
CC-Link/LT from the station does not need any parameter settinggs Q25PRHCPU Manual.
Only need to set up the transmission speed in the master module, you can use the remote I/O.
QJ61CL12 can be used as the main station of CC-Link/LT.