OMRON D4NH-8EAS INSTRUCTION sheet PDF

Ratings: Standard load; 4 A at 30 VDC.
Cable: VCTF oil-resistant cable *1.
Actuator: Crossroller plunger.
Cable length : 5 m.
Compact Limit Switch That''s Also D4NH-8EAS PDF.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models.)
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material D4NH-8EAS
Cable lengths of 3 and 5 m available on standard models D4NH-8EAS PDF.
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers.
Models with red LED indicators added to series for easy,
confirmation of operation.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking D4NH-8EAS PDF.
(Applicable only to standard models.)Terminal: Screw terminal (-B).
Actuator: Hinge roller lever; High OT.
DPDT Basic Switch for Two.
Independent Circuit Control.
Ideal for switching the circuits operating on two,
different voltages, and for controlling two independent circuits OMRON INSTTRUCTION sheet D4NH-8EAS Manual.
Interchangeable with OMRON Z Basic Switches,
as both switches are identical in mounting hole,
dimensions, mounting pitch and pin plunger position. Optical System Achieves 1-μm Operating Position.
Repeatability in this 4-way Switch.
No-contact structure for high reliability.
Ceramic materials in measuring part for superior resistance to abrasion OMRON INSTRUCTION sheet.
Two different output types (PNP and NPN) available. ,
Less abrasion and damage of mechanical contacts compared,
to switches with contacts, reducing fluctuation in the output.
More compact than previous OMRON models: 40% less mass,
15% lighter across the operating width OMRON INSTRUCTION sheet. Specifications: I/O;
NPN (input: + common, output: - common);
Input: 8 points/Output: 8 points.
I/O connections: M3 Screw terminals.
Rated internal circuit power supply voltage:
Supplied from the communications connector.
Rated I/O power supply voltage: 24 VDC.
Allows I/O Expansion with Transistor Terminals.
Wide variety of data, such as maintenance system data,
can be collected without affecting the productiviity,
of the control system D4NH-8EAS INSTRUCTION sheet.
Valuable information can be collected,
and managed through the network, including information,
on the communications power supply.
voltage levels, Unit wear and tear,
and equipment operating informattion D4NH-8EAS Manual.
Expansion via Expansion I/O Units.
With no communications baud rate settings,
required and detachable terminal blocks,
maintenance is easier.