OMRON E2CY-T11 INSTRUCTION sheet PDF

Power supply voltage: 12 to 24 VDC.
Output configuration: Open-collector output (NPN output).
Output phases: Phases A .
Resolution (pulses/rotation): 10, 20, 60, 100, 200, 300, 360, 500 E2CY-T11 PDF.
Compact Encoder with External.
Diameter of 25 mm.
Incremental model.
External diameter of 25 mm.
Resolution of up to 500 ppr. Appearance: T-shaped.
Sensing method: Through-beam type (with slot) E2CY-T11
Cable length: 2 m.
Sensing distance: 5 mm (slot width).
configuration Output: Dark-ON.
Indicator mode: Incident light.
Model: NPN output.
Slim, Compact Photomicrosensor.
that is still easy to use.
Compact, thin profile enables dense mounting E2CY-T11 PDF.
Indicator is visible from both sides.
Wide operating voltage range: 5 to 24 VDC. Size: 48 x 996mm E2CY-T11 Manual.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling E2CY-T11 PDF.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-485.
General thermostat new high performance (high resolution, high speed, high precision input) type products OMRON INSTRUCTION sheet.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0 OMRON INSTRUCTION sheet. 01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermoostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV OMRON INSTRUCTION sheet E2CY-T11 INSTRUCTION sheet.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output E2CY-T11 Manual.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type.