OMRON E2E-C1B1 INSTRUCTION sheet PDF

Power supply voltage: 5 to 12 VDC.
Output configuration: Voltage output.
Resolution (pulses/rotation): 300, 360, 500, 600, 720, 800, 1,000, 1,024;
1,200, 1,500, 1,800, 2,000, 2,048; 2,500, 3,600 E2E-C1B1 PDF.
Hollow-shaft Encoder.
Incremental model.
External diameter of 40 mm.
Resolution of up to 3,600 ppr.
Slim design at only 26 mm thick. Sensing method: Diffuse-reflective Sensors.
Appearance: Vertical E2E-C1B1
Connection method: Connector (M12).
Sensing distance: 700 mm .
Functions: --.
Model: NPN output.
Ordering Information.
Built-in Amplifier Photoelectric Sensors. Sensing method: Diffuse reflective E2E-C1B1 PDF.
Appearance: Vertical.
Connection method: Pre-wired .
Sensing distance: 12±2 mm.
Model: PNP Open collector output type .
Both Red-light Models and Green,
light Models to Detect a Wide Variety,
of Colors. Appearance: M4.
Sensing distance: 2 mm.
CConnecting method: M8 Pre-wired Connector Models (0 E2E-C1B1 PDF E2E-C1B1 Manual. 3 m).
Cable specifications: PVC (oil-resistant).
Operation mode: NC.
Wire color /pin arrangement: 1: +V, 3: 0 V, 4: Control output.
Model: NPN output.
Ultra small size, but surprisingly easy installation!
With the addition of M4, 5.4-dia., 6.5-dia. size, unshielded,
pre-wired connector model, and connector model, a total of,
108 model variations are available OMRON INSTRUCTION sheet.
High-speed response frequency stably detects moving,
objects: 5 kHz max.
Four indicator lamps for easier indicator positioning.
Special mounting brackets reduce time and efforts for,
installation.
Protective Stainless-steel Spiral Tube against wire,
breakage is available (M4, M5 only) OMRON INSTRUCTION sheet.
Models also available with standard cables that are 5 m long,
or with robot (bending-resistant) cables. E32-A03-1 type: special beam type; wafer mapping,
Specialty: the opening angle of 1.5 degrees to adjust the optical axis after the factory; with the installation edge,
Bending radius (mm): R10 OMRON INSTRUCTION sheet.
Fiber elemennt for meeting diversified needsSensing method: Reflective model(for mark detection) E2E-C1B1 INSTRUCTION sheet.
Connection method: Pre-wired (2 m).
Sensing distance: 35±5 mm.
Extremely thin beam ideal for detection of minute objects and marks.
Ideal for ddetection of small objects and slight color differences E2E-C1B1 Manual.
Bad mark detection.
Detection of thin wire of 200 μ.
Detection of slight level differences.