OMRON E3C-LDA7 INSTRUCTION sheet PDF

Size: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: silver.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling E3C-LDA7 PDF.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 4.
Transfer output: transfer output (special terminal) E3C-LDA7
Remote SP:4 to 20mA input.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance E3C-LDA7 PDF.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.

All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors E3C-LDA7 PDF E3C-LDA7 Manual.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver OMRON INSTRUCTION sheet. 4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type. Power supply voltage: DC.
Sensing method: Retro-reflective with MSR function OMRON INSTRUCTION sheet.
Sensing distance: 10 m[100 mm](When using E39-R2).
Output configu ration: PNP.
Long-distance Photoelectric Sensor.
That Supports AC/DC Power Supplies.
Long sensing distance that is approximately 8,
times that of our conventional model (for the,
Through-beam and Diffuse-reflective models) OMRON INSTRUCTION sheet.
(Through-beam: 40 m, Retro-reflective: 7 m, and,
Diffuse-refllective: 2 E3C-LDA7 INSTRUCTION sheet. 5 m.) .
Improved visibility:
A red LED that makes the spot visible.
Large indicators that can be seen even from a,
distance.
Improved operability.
(Enlarged sensitivity adjuster and operation selector)
Freely selectaable power supply input (24 to 240 VDC, 24 to 240 VAC) E3C-LDA7 Manual.
(Additional types added to the DC type lineup.)
Models with infrared LEDs are also available.