MITSUBISHI GT01-RS4-M datasheet PDF

Cable length: 3m.
Connection between serial communication unit and GOT. Connection between a computer link unit and a GOT.
For the connection between AJ65BT-R2N and GOT (only GT09-C30R2-9P).
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Protective film for 15 inch screen GT01-RS4-M PDF.
Transparent (frame: white), 5.
Applicable model: GT15. Protective film for 10.4 inch screen GT01-RS4-M
Transparent (frame: white), 5.
Applicable model: GT16. Protective film for 4.5 inch screen.
Transparent (frame: white), 5.
Applicable model: GT1030. Cable length: 3m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT GT01-RS4-M PDF.
Applicable models: GT10, GT21. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. For video input (NTSC/PAL) 1ch, video recording / animation file playback.
Applicable model: GT27. Protective film for 8.4 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. No extended memory.
Applicable model: GT15. Protective film for 15 inch screen GT01-RS4-M PDF.
Scrub (frame: white), 5.
Applicable model: GT15. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re caliibrated to the touch screen system GT01-RS4-M datasheet.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT01-RS4-M datasheet.