MITSUBISHI GT2715-XTBD datasheet PDF

Cable length: 30.6m.
Long distance connection between CPU (A Series) and GOT for QnAS/AnSCPU/ motion controller.
Long distance connection between A7GT-CNB and GOT.
Applicable models: GT16, GT15, GT11. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT GT2715-XTBD PDF. Protective film for 10.4 inch screen.
Transparent, 5.
Applicable model: GT12 GT2715-XTBD For MES interface functions.
Applicable model: GT16. Oil resistant cap for 15 inch screen.
Applicable model: GT16. Cable length: 1m.
Used to extend the USB port of the GOT to the control cabinet.
Applicable models: GT10, GT21. Cable length: 5.0m.
For the connection between QCPU and GOT.
For connection between two GOT GT2715-XTBD PDF.
Applicable models: GT16, GT15, GT11, GT27, GT25. Accessories for 10.4 inch models.
Applicable models: GT16, GT15. Cable length: 3m.
Connection between serial communication unit and GOT. Connection between a computer link unit and a GOT.
For the connection between AJ65BT-R2N and GOT (only GT09-C30R2-9P).
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Protective film for 5 GT2715-XTBD PDF. 7 inch screen.
Scrub (frame: white), 5.
Applicable model: GT11. Coaxial bus unit.
Applicable models: GT15, GT16, GT27, GT25. RS-232 serial communication unit (D-sub9 pin (header).
Applicable models: GT15, GT16, GT27, GT25. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibbrated to the touch screen system GT2715-XTBD datasheet.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2715-XTBD datasheet.