MITSUBISHI MR-J2S-CLP01 datasheet PDF

MR-J2M multi axis servo amplifier expansion unit.
1, the servo controller through the automation interface can be easily carried out the operation module and the conversion of the field bus module,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J2S-CLP01 PDF MR-J2S-CLP01
2, the servo controller is directly connected with the rotary transformer or encoder, and the speed and displacement control loop is formed.
The general inverter can only form an open loop control system.
3 servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter MR-J2S-CLP01 PDF. Cable length: 20m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life. Drive: MR-H_ACN series CC-LINK features.
Rated output: 22KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-J2S-CLP01 PDF.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. Type: MR-J series.
Rated output: 3.5KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot contrrol of the indexing table MR-J2S-CLP01 datasheet.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MR-J2S-CLP01 datasheet.
Encoder serial communication system, the communication frequency can only be limited to 10M.