MITSUBISHI MR-J4-500A4 datasheet PDF

Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 22KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J4-500A4 PDF.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control MR-J4-500A4
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter MR-J4-500A4 PDF. Fiber length: 30 meters.
SSCNET III cable (long distance optical fiber, high bending life).
Joints for CN1A and CN1B. Servo amplifier side connector.MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 2.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MR-J4-500A4 PDF.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other opperations MR-J4-500A4 datasheet.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J4-500A4 datasheet.
When the two stations are occupied, the speed can be set directly by the remote register.