MITSUBISHI Q00CPU datasheet PDF

1 channels.
Input (weighing sensor output): V/V 0.0~3.3m.
Output (resolution): 0~10000.
Conversion speed: 10ms.
18 point terminal.
Weighing sensor input module capable of directly connecting with all kinds of weighing sensor.
The weighing sensor can now be directly connected to a programmable controller system,
Without the need for an external connection to the signal converter, etc Q00CPU PDF. .
By ensuring the accuracy of the weighing sensor, stable data conversion speed,
To achieve a high precision measurement Q00CPU
No external signal converter!
The weighing sensor input module is directly connected to the programmable controller, which can reduce the time and cost of the sensor!
Various types of weighing sensors can be connected with the magnetostrictive type, capacitive type, rotary instrument or strain gauge Q00CPU PDF.
Can connect 6 wire system (combined with remote sensing technology and ratio method) or 4 wire system weighing sensor. SRAM+E2PROM memory card.
RAM capacity: 512KB.
E2PROM capacity: 512KB. 8 slots.
Requires 1 power modules.
Used to install the old section of the large A series PLC module Q00CPU PDF.
Switch volume control is designed to,
According to the current input combination of the switch quantity and the history of the input sequence,
So that PLC generates the corresponding switching output,
In order to make the system work in a certain order.
So, sometimes also known as the order control.
And sequential control is divided into manual, semi-automatic or automatic.
And the control principle is decentralized, centralized and hybrid control three.
Each scanning process. Focus on the input signal sampling. Focus on the output signal to refresh.
Input refresh process. When the input port is closed,
Program in the implementation phase, the input end of a new state, the new state can not be read.
Only when the program is scanned, the new state is read.
A scan cycle is divided into the input sample, the program execution, the output refresh.
The contents of the component image register are changed with the change of the execution of the program.
The length of the scan cycle is determined by the three.
CPU the speed of executing instructions.
Time of instruction.
Instruction count.
Due to the adoption of centralized sampling.
Centralized outputt mode Q00CPU datasheet.
There exist input / output hysteresis phenomena, i.e., the input / output response delay.
System program memory for storing system program,
Including management procedures, monitoring procedures, as well as the user program to do the compiler to compile the process of interpretation Q00CPU datasheet.
Read only memory. Manufacturers use, content can not be changed, power does not disappear.