OMRON E2C-EDA51 2M datasheet PDF

Pressure range: Positive pressure; 0 to 1 MPa.
ON/OFF output: Open collector (two independent outputs).
Linear output: 1 to 5 V.
Model: NPN output.
Pressure Sensor with.
Easy-to-Read LED Display.
Pressure status can be checked at a glance from the,
digital display and bar display.
Measurement pressure prevents incorrect outputs due,
to momentary pressure changes E2C-EDA51 2M PDF.
Perform automatic teaching simply by teaching pressure,
values for good and bad products E2C-EDA51 2M
Industry’s smallest models at just 28 × 28 × 29 mm.
Only in hysteresis mode. Slit width: 0.5 mm dia.
Installation procedure: Plug-in type.
Applicable type: E3Z-T@@. Appearance: Unshielded, M30.
Sensing distance: 18 mm.
Model: Operation mode, NO E2C-EDA51 2M PDF.
Proximity Sensor with a Long Screw Length.
Increased tightening strength. Cable protectors,
provided as a standard feature.
Increased indicator visibility.
A milled section for wrench grip on all models. E3JK-D11 diffuse reflection type,
E3JK direct current mode: mode; ON,
Miniature amplifier built-in type photoelectric switchSize: 48 x 96mm.
Category: power AC100 ~ 240V with E2C-EDA51 2M PDF.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 4.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makees the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E2C-EDA51 2M datasheet.
Through the infrared port can be carried out from the frront of the communication E2C-EDA51 2M datasheet.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.