OMRON E52-P35C-N D=4.8 datasheet PDF

Sensor type: BGS (background suppression).
Sensing distance: 200 mm.
Connection method: pre-wired.
Model: NPN output.
A new generation in sensing performance.
Simplicity.
Simple selection.
Simple installation.
One family for all.
All standard applications covered.
A wide variety of models.
Models designed for special applications E52-P35C-N D=4.8 PDF.
Non-stop detection.
High quality and reliability E52-P35C-N D=4.8
High EMC protection.
High light immunity.
Robust and waterproof housing. Fitting materials: Iron, zinc plating.
Count: 1 .
Accessories: Description, Phillips screws M2.3 × 8,
Spring washer M2.3;
Material, Iron, zinc plating, Iron, zinc plating;
Count, 4; 4 .
Applicable sensor (mounting pitch on sensor side): E3C-S10 (7 E52-P35C-N D=4.8 PDF. 5).
Page: Dimensions, 12. Aluminum and Iron Both.
Detectable from Long Distances. Sensing distance: (See note 2.)0 to 3.5 mm(pressed position) (See note 1.).
Sensing method: Pushbutton.
Operation mode: OFF with no load.
Cable length: 1 m (robot cable).
Model: NPN output .
Using a pushbutton enables,
accurately detecting difficult-to-detec objects.
Conforms to standards for semiconductor FOUP cassettes to ena,
accurately detecting FOUP cassettes without being affected by the,
material, color, or reflectance of the bottoms of the cassettes E52-P35C-N D=4.8 PDF.
Thin design enables mounting in a wider range of applications, e.g.,
on transfer arms.
Increased visibility with 4-direction indicator.
Optical detection of actuator operation provides a long life,
(mechanical life: 5 million operations min.).
Models available with PNP or NPN output.
Models are available with very flexible robot cable. E3JM-10S4T detection methods: the firing pattern,
Connection: terminal plate,
Detection range: 10m.
Output status: ON into the light; light shading ON; switch conversion type.
Function: timer,
Output: DC no contact.
2 types of cost reductionSize: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: silver.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 4.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the statee of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV E52-P35C-N D=4.8 datasheet.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output E52-P35C-N D=4.8 datasheet.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type.