OMRON E5CN-R2HBL datasheet PDF

Fitting materials: Stainless steel (SUS304).
Count: 1 .
Accessories: Description,Slotted/Phillips screws M3 × 8,
(with spring and plain washers);
Material, Stainless steel (SUS304);
Count, 2 .
Applicable sensor (mounting pitch on sensor side): E3Z pre-wired model.
Page: Dimensions, 13. Type: high temperature E5CN-R2HBL PDF.
Measuring temperature range: 0 ~ +1000.
The target size: 35mm diameter (from 1000mm) E5CN-R2HBL
No need to contact the workpiece, you can measure the temperature.
Achieve no damage, health and efficient temperature management.
A small spot diameter 3mm and 8mm diameter two types.
Reproduction of positive and negative 0.5 degrees Celsius, response speed of 0.4 seconds,
(95%) with high precision and high speed measurement E5CN-R2HBL PDF.
In addition to the original middle temperature (0 ~ +500 C),
Also added in low temperature (- 50 DEG C ~ +500),
High temperature (0 ~ +1000 degrees C) models.
New measurement distance up to 500mm, 1000mm long distance type.
Use another programmer, can change the temperature monitoring, radiation rate,
Moving average function and output range.
(picture for the installation of programmer in the ES1 body)Size: 48 x 48mm E5CN-R2HBL PDF.
Control output 1: relay output.
Control output 2:--.
Auxiliary output: 3 points (common universal).
Power supply voltage: AC/DC24V.
Terminal type: screw terminal table type.
Input category: full range multi input.
Heater break, SSR fault detection function: -.
Communication: RS-485.
Event input: 1 points.
Remote SP input: -.
Transfer output: -.
Using large font PV display (white), improve visibility.
Selection, operation and setting.
Functional performance of input and output points.
Support for more extensive range of applications.
Using high PV 15.2mm display (white), improve visibility.
High speed sampling to achieve 50ms.
With auxiliary output (maximum 3 points), event input (maximum 4 points), the transmission output,
Remote SP input function, support for a variety of applications E5CN-R2HBL datasheet.
E5CC 60mm has a depth of slender body.
The use of communication adapter cable (sold separately) connected with a computer.
After that, no power supply connection can be set.
It can be easily set by CX-Thermmo (sold separately) E5CN-R2HBL datasheet.
Easy to connect with PLC through no program communication.
Combined temperature control device through component communication.