Name: CJ1 Special I/O Unit.
Specifications: Type of communications,
Remote I/O communications, Message communications;
Maximum number of I/O points per Master Unit,
Word Slave Units: 1,024 inputs and 1,024 outputs,
(2,048 I/O points total)Bit Slave Units:
256 inputs and 256 outputs (512 I/O points total) CP1E-N14DT-A PDF.
No. of unit numbers allocated: 1, 2, 4, or 8.
Current consumption : 5V, 0
CP1E-N14DT-A4A; 24V,--.
Standards: CE, U, U1, L, N.
NJ/CJ-series CompoNet Master Units Increase,
the Range of Applicability of Sensors and Actuators.
The NJ/CJ-series CompoNet Master Unit manages,
the CompoNet network, controls communications,
between the Controller and Slave Units,
and handles I/O data and message data CP1E-N14DT-A PDF. Model: C500-COV03.
C500 I / O Control Unit, II / O Interface For unitC500-CT Special I/O Unit High-speed Counter Unit 20 kcps 4 pts C500-CT041 CP1E-N14DT-A Manual. Name: Position Control Module.
Model: C200HW-NC413 CP1E-N14DT-A PDF.
Control method: Open-loop, automatic trapezoid acceleration/deceleration.
Control output sig-nals: Pulse-train outputs.
Controlled axes: 4.4 platinum resistance thermometer inputsModel : CV500-CIF01.
Port for peripherals (6m) 25-pin.Model: C200H-MAD01.
External input points: 2.
External output points: 2 OMRON OPERATION MANUAL.
External input signal range: 1 to 5 V or 0 to 10 V or –10 to 10 V.
External output signal range: 1 to 5 V or 0 to 10 V or –10 to 10 V.1 set (2 included).Output type: Transistor sourcing.
Inputs points: 12 points.
Outputs points: 8 points.Unit type: CS1 CPU Bus Units.
Product Name: MECHATROLINK-II,
compatible Position Control Unit OMRON OPERATION MANUAL.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 4.
No. of unit numbers allocated: 1 OMRON OPEERATION MANUAL CP1E-N14DT-A OPERATION MANUAL.
Current consumption: 5V, 0.36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes,
in a motion networkk with one Position,
Control Unit that supports MECHATROLINK-II CP1E-N14DT-A Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.