OMRON CP1L-L10DR-D REFERENCE MANUAL PDF

Name: e-CON Connectors.
Specifications: Inputs; 16 inputs; NPN;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet CP1L-L10DR-D PDF.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction CP1L-L10DR-D
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error CP1L-L10DR-D PDF. Name: I/O Control Unit.
Specifications: Applicable systems,
Duplex CPU, Dual I/O Expansion System only;
Duplexing, Supported;
Online Replacement, Supported;
Mounting Backplane, Expansion Backplane;
Connecting Cable, CS1W-CN@@3,
CS-series Coonnecting Cable CP1L-L10DR-D PDF CP1L-L10DR-D Manual.
Current consumption: 5V system, 0.20A;
26V system, --.
Standards: UC1, CE.
Redundant CPU Units , Power Supply Units ,
Communications Units ,
and Expansion I/O Cables. For 1 Unit.C500-OC I/O Unit Transistor Output 16 pts C500-OC223-E(3G2A5-OC223-E).
AC250/DC24V 2A.Model: C200H-OC222N OMRON REFERENCE MANUAL.
No. of points: 12 pts.
Specifications: 2A, 250VAC/24VDC(For resistive loads).CV500-HD SYSMAC BUS PC Unit Hard Disk Drive For 100 VAC CV500-HDD01.ASCII Unit
This program runs independently from the ladder-diagram program in the PLC.

Name: ASCII Module.
Model: C200H-ASC21.
Communications port>Port 1: RS-232C(peripheral device or termi-nal connection) OMRON REFERENCE MANUAL.
Communications port>Port 2: RS-422A/485(peripheral Unit classification: CJ1 CPU Bus Units.
Product name: Motion Control Unit with,
MECHA TROLINK-II interface.
Specifications: Control modes : Position,
speed, or torque control via MECHATROLINK-II,
Control axes : 32 axes max OMRON REFERENCE MANUAL. (30 physical axes,
2 virtua axes).
Internal programming language: Special motion controo
language
No CP1L-L10DR-D REFERENCE MANUAL. of unit numbers allocated: 1.
Current consumption: 5V, 0.60A; 24V, --.
Standards: UC1, CE.
Improve Equipment Design Efficiency,
and Shorten Tact Time.
Control Servos for up to 16 axes in,
a motion networkk with one Position,
Control Unit that supports MECHATROLINK-II CP1L-L10DR-D Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.