OMRON CPM2C-20CDTC-D SYSTEM MANUAL PDF

Output method: Transistor sourcing.
Inputs: 12.
Outputs: 8.Connects SYSMAC LINK Unit, Controller Link Unit to CPU Unit.
For 2 Unit.I/O Terminal Cover For 20-pin block, standard C500-COV13Unit type: CJ1 Basic I/O Units CPM2C-20CDTC-D PDF.
Product name: Triac Output Unit.
Specifications: Output type , --;
I/O points, 8 inputs;
Maximum switching capacity, 250VAC, 0.6A;
Commons, 8 points, 1 common;
External connection, Removable terminal block CPM2C-20CDTC-D
No. of words allocated: 1 word.
Current consumption: 5V, 0.22A; 24V, --.
Standards: UC1, N, L, CE.
A Wide Range of Basic Output,
Units for High Speed Output,
and Different Applications CPM2C-20CDTC-D PDF.
These Output Units receive the ,
results of output instructions ,
from the CPU Unit and perform ON/OFF,
control for external devices.
High-speed Output models CJ1W-OD213 and,
CJ1W-OD234 can help to increase system.
throughput. Model : CV500-IPS01.
Input: 100 to 120/200 to 240 VAC Output: 2A, 24 VDCUnit type: CS1 Special analog I//O Units CPM2C-20CDTC-D PDF CPM2C-20CDTC-D Manual.
Product name: Analog Output Units.
Specifications: I/O points, 4 outputs;
Signal range selection,
Set separately for each input;
Signal range, 1 to 5 V, 0 to 5 V,
0 to 10 V, -10 V to 10 V, 4 to 20 mA;
Resolution, 1/4000 ;
Conversion speed, 1 s/point OMRON SYSTEM MANUAL.
Externa connection, Removable erminal block.
Current consumption: 5V, 0.13A; 26V, 0.18A.
Standards: UC1, N, CE.
For Various Analog I/Os.
Analog Input Units for converting,
analog input signals into binary data.
Analog Output Units for converting ,
binary data into analog output signals OMRON SYSTEM MANUAL. Supply voltage: 100 to 240 V AC, 50/60 Hz (wide range).
Operating voltage range: 85 to 265 V AC.
Output capacity: 5 V DC: 6 A 24 V DC: 0.5 A(30 W total, see note).Unit type: CS1 CPU Bus Unit.
Product Name: MECHATROLINK-II,
compatible Motion Control Unit OMRON SYSTEM MANUAL.
Specifications: Control modes: Position,
speed, or torque control via MECHSTROLINK-II,
Control axes: 32 axes max.
(30 physical axes, 2 virtual axes).
Internal programming language: Special,
motion control language CPM2C-20CDTC-D SYSTEM MANUAL.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.80A; 26V, --.
Standards: UC1, CE.
Improve Equipment Design Efficiency and,
Shorten Tact Time.
Control Servos for up to 16 axes in a,
motion networkk with one Position Control,
Unit that supports MECHATROLINK-II CPM2C-20CDTC-D Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.