OMRON E5CN-HV2M-500 Basic Type (Basic Type) PDF

Ultra small rotary encoder (diameter 20) - absolute.
Machine built in super small.
The diameter of 20mm size, resolution 256 (8bit).
Axle and hollow shaft type E5CN-HV2M-500 PDF. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points E5CN-HV2M-500
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved E5CN-HV2M-500 PDF.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling pperiod 60ms E5CN-HV2M-500 Manual.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors E5CN-HV2M-500 PDF.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay) OMRON Basic Type.
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller. The small body of 48 * 24mm specifications on the condensation operation, E5_C series of high performance OMRON Basic Type.
Slender body width 48mm * 24mm * 90mm high depth,
The most suitable for small devices / physical and chemical equipment, etc..
Although the small size, but also through the character of the high 10.5mm white PV display to achieve high recognition OMRON Basic Type.
The terminal stage is adopted to disassemble and assemble the structure, which improves the maintenance performance.
The connecction method can be selected from a screw terminal and a PUSH-IN fastening terminal E5CN-HV2M-500 Basic Type.
High speed sampling of 50ms is realized.
Easy to connect with PLC through no program communication.
The use of electric communication converrsion Village (sold separately) connected to the computer after,
No power connection can be set E5CN-HV2M-500 Manual.
It can be easily set by CS-Thermo (sold separately).