FX1N-40MT-D PLC MITSUBISHI FX1N-40MT-D

Connecting cable for handheld RH GOT and PLC.
Cable length: 6 meters.
Application: RS-422 connection and RS-232C connection. Max input / output points: 16 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points.
Output points: 8 points.
Output type: Transistor (sinktype) FX1N-40MT-D.
Power consumption: 30W.
Weight (kg):0.6.
Size (WxHxD) mm:130x90x86.
Faster and more efficient. Support high speed control and network communication, and have the function of data recording FX1N-40MT-D.
High speed, large capacity, multi-function high-end machine.
FX3U supports high speed processing, CC-Link communication, network communication, analog control and advanced positioning system.
Connected to the CC-Link, including the remote I/O, the maximum input and output control points up to 384 points,
Can correspond to a variety of field needs, the use of its scalability and flexibility to expand the scope of application of the control system FX1N-40MT-D.
Third generation high function micro programmable controller.
High speed, high efficiency, high performance, large capacity, and new features MITSUBISHI FX1N-40MT-D.
Built in high speed processing and positioning.
Control points: maximum 256 points.
Use CC-Link remote I/O for 384 points.
Max input / output points: 40 points.
Power supply voltage: DC24V.
Input points: 24 points.
Output points: 16 points MITSUBISHI FX1N-40MT-D.
Output type: transistor.
Power consumption (W): 32.
Weight (kg):0.65.
Size (WxHxD) mm:130x90x75.
FX1N series is a very powerful micro PLC, can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect MITSUBISHI FX1N-40MT-D.
A PLC unit can output 2 100KHz pulses at the same time,
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute position readout, absolute or relative drive, and special pulse output control. Input points: 16 points.
AC input signal type. Analog output expansion board (1 channel).
Can be installed in FX1N, PLC FX1S, providing 1 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space.
Can easily control the speed of the inverter. Protocol: SLMP, TCP/IP, UDP, SNTP.
Communication mode: full duplex / half duplex.
At the same time can open a few: 4 connection.
Weight: 0.3kg.
Can be low cost will be connected to the FX3 series Ethernet.
Support data monitoring, can monitor the basic unit through the computer browser,
Remote maintenance can be carried out by Works2 GX in a place far from the scene FX1N-40MT-D.
Connect FX3SA, FX3S, FX3GA, FX3G, FX3U host, you need to convert the adapter or function expansion board.