MITSUBISHI MR-JE-100A amplifier MITSUBISHI MR-JE-100A

Type: MR-J_B series.
Rated output: 1.0KW.
Interface: standard.
Servo system according to the system structure can be divided into open loop servo system, closed loop servo system, semi closed loop system, compound control system.
The closed loop automatic control system with feedback is composed of a position detecting part, a deviation amplifying part, an executing paart and a controlled object MR-JE-100A.
Servo system must have good controllability, high stability and high adaptability.
Note that the control of the signal is good after the disappearance of the signal, can immediately stop the turn;
High stability is the torque with the increase of speed and uniform decline; adaptability is fast, sensitive, and ring state quality is good MR-JE-100A.
According to the types of servo drives are classified, there are three kinds of electric, hydraulic or electric hydraulic MR-JE-100A.
If the servo system is divided according to the function, then there is a measuring servo and power servo system;
Analog servo and power servo system; position servo and acceleration servo system.
The electric servo system can be divided into two categories: DC DC servo system and AC AC servo system based on the electrical signals MITSUBISHI MR-JE-100A.
AC AC servo system also has two kinds of asynchronous motor servo system and synchronous motor servo system. The length of the line: 2M.
IP level: IP65.
Direct type MITSUBISHI MR-JE-100A.
Bending life: standard.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction).
MITSUBISHI universal AC servo amplifier MELSERVO-JE series.
Rated output: 1.0kw.
Interface: General purpose MITSUBISHI MR-JE-100A.
Compatible motor: HG-KN102J-S100, HG-KN102BJ-S100.
MR-JE-A is equipped with a positioning function!
Be able to realize the positioning of the point set list and the way of the program.
At the same time, it also has a simple cam, encoder to follow, mark detection and other equipment can achieve high performance of the advanced functional group.
Without positioning module, the controller can build a positioning system, which can simplify the system.
Command interface using DI/O and RS-422/RS-485 serial communication (maximum 32 axis),
Can simply set the positioning data through the Configurator2 MR. Uses: MR-BAT6V1SET-A, MR-BT6VCASE use.Superior high efficiency IPM motor.
Output power: 0.75kw.
Rated speed: 1500rr/min MR-JE-100A.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time.