MITSUBISHI MR-JE-40A amplifier MITSUBISHI MR-JE-40A

The length of the line: 0.3m.
Encoder with cable (motor side), for the HF-KP/HF-MP series (motor shaft with side extraction). Drive: MR-H_ACN series CC-LINK features.
Rated output: 3.5KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer MR-JE-40A.
The host computer sends the speed command signal to the servo drivver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MR-JE-40A. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-JE-40A.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MITSUBISHI MR-JE-40A.
MITSUBISHI universal AC servo amplifier MELSERVO-JE series.
Rated output: 0.4kw.
Interface: General purpose.
Compatible motor: HG-KN43J-S100, HG-KN43BJ-S100.
MR-JE-A is equipped with a positioning function!
Be able to realize the positioning of the point set list and the way of the program MITSUBISHI MR-JE-40A.
At the same time, it also has a simple cam, encoder to follow, mark detection and other equipment can achieve high performance of the advanced functional group MITSUBISHI MR-JE-40A.
Without positioning module, the controller can build a positioning system, which can simplify the system.
Command interface using DI/O and RS-422/RS-485 serial communication (maximum 32 axis),
Can simply set the positioning data through the Configurator2 MR. The length of the line: 10M.
IP level: IP67.
Bending life: high bending life.
Encoder cable for 15K1M, 11K1M4, HF-JP11K1M, 15K1M4. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.6kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
2 low frequency vibration can be suppressed at the same time by supporting the seismic algorithm of 3 inertial equipment.
Configurator2 MR to achieve convenient adjustment.
Effectively restrain the low frequency aftershock effect produced by the front end of the boom or the main body of the device 100Hz.
Can effectively shorten the time to control the stability of the aftershock.
In thee XY design of trajectory control, improve the accuracy of arc track MR-JE-40A.
At the same time, it can effectively control the phenomenon of quadrant protrusion caused by the rotation direction of the servo motor, which is caused by friction and twisting.