MR-J100A | MITSUBISHI Servo driver MR-J100A
Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life.
Coding is not resistant to oil.
Type: MR-J series.
Rated output: 0.2KW.
Suitable for motor series: HA-ME MR-J100A.
Voltage: single phase AC100V.
It is very helpful to immprove the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MR-J100A.
This can be effectively used in the use of the robot control of the indexing table MITSUBISHI MR-J100A.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment MR-J100A.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MITSUBISHI MR-J100A.
Encoder serial communication system, the communication frequency can only be limited to 10M. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 55kw.
Interface: universal type.
Power supply: three phase AC400V MITSUBISHI MR-J100A.
Special specifications: full closed control 4 wire / support mechanical end encoder ABZ phase input / support positioning mode.
Support position control, speed control, torque control.
Position control to follow the position instructions.
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Function of switching amplitude. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth.