OMRON SGE-245-0-0600L 05000C-05000C

CV500-RT SYSMAC BUS Remote I/O Slave Unit (wired) CV500-RT221.
Wire Type.Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: linear voltage output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points .
Heater break, SSR fault detection function: - SGE-245-0-0600L 05000C-05000C.
Event input points: -.
Transfer output: output (using control output) SGE-245-0-0600L 05000C-05000C
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure SGE-245-0-0600L 05000C-05000C.
High resolution 5 bit display / can display 0 . 01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV SGE-245-0-0600L 05000C-05000C.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay) .
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller. Compact, Resistant to Mutual.
Interference, and Ideal for Picking a Variety of Parts.
Mounts to a parts rack and uses indicators to show parts,
picking procedures. Functions as a mistake-proofing Sensor.
Use either the built-in LED indicators or external picking indicators. Appearance: Round/Full-guard type LED lighting,
(without Voltage Reduction Unit) A22L-G.
Output: SPST-NO + SPST-NC.
Lighting: LED.
Operating voltage: 24 VAC/VDC.
Operation: Alternate operation (self-holding).
Illumination color: R (red); Y (yellow); G (green); W (white); A (blue).
Install in 22-dia. or 25-dia. Panel Cutout.
(When Using a Ring).
Lever for eeasily mounting and removing the Switch Unit SGE-245-0-0600L 05000C-05000C.
Increase wiring efficiency with three-row mounting of Switch Blocks.
Finger protection mechanism on Switch Unit provided as a standard feature.
Use 25-dia. ring to install in 25-dia. panel cutouts.
Mounteed using either open-type (fork-type) or closed-type SGE-245-0-0600L 05000C-05000C.
(round-type) crimp terminals.
IP65 oil resistance (non-lighted models).
IP65 (lighted models).
SGE-245-0-0600L 05000C-05000C Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=SGE-245-0-0600L 05000C-05000C&select=5