OMRON XM2S-1511

Number of notches: 3 notches.
Output: DPDT.
Reset method: Manual.
Key release position: Left, right, and center.
Separate Construction with Cylindrical.
16-dia. Body.
Short mounting depth, less than 28.5 mm below panel.
Wide range of switching capacity from standard to microload.
Oil-resistant IP65 models . Actuator: Adjustable rod lever: 25 to 140 mm XM2S-1511.
Indicator: Neon lamp.
Item: High-sensitivity XM2S-1511
Pretravel (PT): 10°.
Select the Best Two-circuit Switch for the,
Operating Environment and Application,
from a Wide Range of Models,
A wide selection of models is available, including General-purpose,
Environment-resistant, and Spatter prevention Switches XM2S-1511.
Standard-feature gold-clad crossbar contacts provide high reliability .
Applicable to either standard loads or microloads.
Switches with Lever Actuators provide 90° overtravel,
one-side operation, and four-direction head mounting.
Approved standards: EN/IEC, UL, cUL, and CCC.
Contact your OMRON representative for information on approved models. Optical system: Diffuse reflective.
Measurement range: Height direction, 210±48 mm;
Width direction, 70 mm (typical) XM2S-1511.
Resolution: Height direction, 6 μm;
Width direction, 111 μm (70mm/631pixels).
ZG2 debut!
Achieving stable measurement.
through innovative technology. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-422.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Throuugh the support software (VVer XM2S-1511.4.3 CX-Thermo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output.
Through the infrared port can be carried out from the frronnt of the communication XM2S-1511.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
XM2S-1511 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=XM2S-1511&select=5