OMRON D3V-6-1A4

Type: no wing.
Drive shaft type: semi cylindrical plug type.
Outlet hole: side 2.
Even number: 3.
Rubber material: NBR.
Head and body integration, strength and sealing performance is better, mechanical life is also significantly increased (5 million times).
The most suitable for a variety of machine tools, automatic production line of the order control D3V-6-1A4.
With drain holes, oil and water can be discharged after immersion D3V-6-1A4 Actuator: Arm lever.
Conduit size: 1-conduit; G1/2.
Built-in switch mechanism: 2NC (Slow-action).
Compact, Plastic-body Safety-door.
Hinge Switch Designed for Saving.
Space in Machines and Other.
Equipment.
Lineup includes three contact models with 2NC/1NO and D3V-6-1A4.
3NC contact forms in addition to the previous contact forms .
1NC/1NO, and 2NC. Models with MBB contacts are also available.
Standardized gold-clad contacts provide high contact reliability.
Can be used with both standard loads and microloads. CompoNet sensor communication unit, simplify sensor settings and management.
No program can be transmitted to the ON/OFF signal PLC (CompoNet communication from the station function) D3V-6-1A4.
Support setting content to the detection threshold, quantity and function of reading, writing and teaching operation (explicit message function).
The assembly is simple, just use the communication cable to connect the E3X-CRT and the amplifier next to it.
Up to 16 sensor amplifiers can be connected. Cable: With cable.
Connector: Connectors on both cable ends.
Cable length L: 0.5 m.
Minimum order: 5.
Small Round Water-resistive.
Connectors.
Water-resistive, compact connector meets IP67 requirements.
Conventional M8 screw-mounting models are available along with,
S8 snap-in models that connect and disconnect with one touch.
Ideal for a wide variety of FA and OA applications.
Connectors on both cable ends require no harness work.
Some new M8 models with 3 or 5 poles. Size: 48 x 48mm.
Body: terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
SSR fault detection function for heater with broken line: detection function for single phase heater.
Event input points: -.
Transfer output: -.
Communication: RS-485.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance, using a new type of liquid crystal, visual angle, contrast to enhance.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
All models (thermocouple /Pt/ analog input switching), 1 macchines to support a variety of sensorss D3V-6-1A4.
Add PV/SV state display function, to see the state of the thermostat.
(automatic / manual, RUN/STOP, alarm), interactive display PV/SV.
By supporting software (CX-ThermoVer.4.0) to carry out a simple function (AND/OR logic and delay),
Be able to eeexecute flexible contact output
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault
D3V-6-1A4 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=D3V-6-1A4&select=5