MITSUBISHI GT1672-VNBD

"Differential driver output.
Axis of control: 2.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
Module backup function: the positioning data, module start data saved to the flash ROM (no battery).
Boot time (operation cycle 0.444ms, 1 axes): 0.3ms.
Maximum output pulse: 5000000 pulse/s .
The maximum distance between servo system: 10m GT1672-VNBD.
External wiring connection: 40 pin connector two GT1672-VNBD
Linear interpolation: 2 axes.
Arc interpolation: 2 axes.
Easy positioning control
The positioning module uses the position control and speed control, which is set by the engineering software.
In the position control and speed control is also equipped with an increase in the "conditional judgment" after the implementation of the specified positioning data and other advanced positioning control functions GT1672-VNBD.
For example, in the automobile door sealing process, the need to carry out high precision positioning control,
In order to applying sealant on the sealing part of the door.
Therefore, it is necessary to track the precise trajectory through the straight line and the arc, and implement the high precision interpolation control GT1672-VNBD.
Multiple start mode
In addition to the conventional positioning module startup, there are high-speed start, multi axis at the same time, such as the start of a variety of ways to start.
High speed start by analyzing the location data to be executed in advance,
High speed startup mode without data analysis time.
Multi axis simultaneous start up mode for starting output pulse at the same time that the object shaft is started simultaneously with the start of the shaft.
In addition, the module can be started to run according to a plurality of positioning data groups in turn at startup.
Can be used for repetitive control of the same locus. "USB interface protection cover on the front panel of the host computer (for replacement).
For 5.7 inches.
Applicable models: GT15, GT11. Master station module for CC-Link.
FX2N-16CCL-M is the PLC CCC-Link as the FX master mmodule GT1672-VNBD.
Up to 7 remote I/O stations and 8 remote stations can be connected to the main station.
Using the CC-LINK FX2N-32CCL interface, you can install PLC FX as CC-LINK remote device station to connect.
In addition, through the connection of varioouss equipment manufacturers, can be applied to a variety of purposes of the system GT1672-VNBD.
The most suitable for production lines and other equipment control.
GT1672-VNBD Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=GT1672-VNBD&select=5