MITSUBISHI 400

Power: 15kw.
Voltage: 200V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Motor suitable for 5.5 to 37kW. Extension board for connection with special adapters
(FX1S and FX1N host general). Type: general purpose AC servo amplifier MR-E series .
Rated output: 0.4kw.
Interface type: general purpose pulse interface 400.
KH003 special mark for Super MR-E 400
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072).
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning 400.
Has 2 types of interfaces:
Position control and speed control with pulse train interface.
The analog input interface is used for speed control and torque control. Used in FX0N-30EC or FX0N-65EC type extensions to extend power extended modules or special modules.
Connection relay as extension cable and module side standard cable. Input voltage range: DC24V 400.
Output voltage: DC5V .
Output current: 2.5A.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30%.
The following describes the centralized control system I/O points of the estimate.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the nnormally open contact is closed,

Provide load current and voltage 400.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is discoonnnected from the load 400.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.
400 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=400&select=5