OMRON 44556-0010 SB-INT-01

MITSUBISHI motor produced PLC connection cable.
Size: A, 2000mm; B, 1750mm.
Input use.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Actuator: Pin plunger.
Subminiature Models.
Capable of Large-capacity.
load of 7A .
Snap-action switch allows large-capacity 44556-0010 SB-INT-01.
switching (7A at 250 VAC) in spite of its small size 44556-0010 SB-INT-01
Particularly suitable as control switches for,
applications where there are restrictions on,
installation space and weight. Size: 48 * 48mm, terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: linear voltage output 44556-0010 SB-INT-01.
Control mode: standard or heating cooling .
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: -.
Event entry point: 2.
Transfer output: output (using control output).
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved 44556-0010 SB-INT-01.
Can be set up to 8 procedures (mode) x 32 (step) procedure .
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller. Appearance: Round/Projection type A22-T.
Output: SPST-NC + SPST-NC.
Operation: Momentary operation (self-resetting).
Illumination color: R (red); Y (yellow); G (green);
W (white); A (blue); B (black).
Install in 22-dia. or 25-dia. Panel Cutout.
(When Using a Ring).
Leever for easily mounting and removing the Switch Unit 44556-0010 SB-INT-01.
Increase wiring efficiency with three-row mounting of Switch Blocks.
Finger protection mechanism on Switch Unit provided as a standard feature.
Use 25-dia. ring to install in 25-dia. panel cutouts.
Mounteed using either open-type (fork-type) or closed-type 44556-0010 SB-INT-01.
(round-type) crimp terminals.
IP65 oil resistance (non-lighted models).
IP65 (lighted models).
44556-0010 SB-INT-01 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=44556-0010 SB-INT-01&select=5