MITSUBISHI A1SJ71LR25

Input / output form: relay output.
Output points: 16 points.
DC5V internal consumption current: 100mA.
DC24V internal consumption current: 125mA.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256 .
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points A1SJ71LR25 Bus cables used for GOT1000 to replace the ferrite cores used in the existing GOT-A900 bus cables.
Applicable models: GT16, GT15, GT11. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series A1SJ71LR25.
Rated output: 5.0kw.
Interface type: general pulse interface type .
Power specification: three phase AC200V.
Pulse train and analog input as universal interface.
Can choose the position, speed and torque control mode.
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use A1SJ71LR25.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. Protective film for 15 inch screen.
Scrub (frame: white), 5.
Applicable model: GT16. Storage capacity: 64MB.
Applicable models: A985 (-V) /A975/A970/A960GOT (-B). Length: 1 meters.
Purpose: MR-JE-A, MR-TB50 connection with. Power: 30kw.
Voltage: 200V.
There are 100% braking torque output in continuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space and reduce the comprehensive cost.
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving. According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the systemm A1SJ71LR25.
MITSUBISHI PLC initialiization procedure . After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program aree: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc A1SJ71LR25. . "
A1SJ71LR25 Operation manual / Instructions / Catalog download link: /searchDownload.html?Search=A1SJ71LR25&select=5